dead weight tester pressure gauge calibration
Description dead weight tester pressure gauge calibration
Piston dead weight tester pressure calibration is a calibration
standard machine which uses a piston cylinder on which a load is
placed to make an equilibrium with an applied pressure underneath
the piston. Dead weight testers are so called primary standards
which means that the pressure measured by a deadweight tester is
defined through other quantities; Length, mass and time. Typically
deadweight testers are used in calibration laboratories to
calibrate pressure transfer standards like electronic pressure
measuring devices.
Detailed Images dead weight tester pressure gauge calibration
Specification dead weight tester pressure gauge calibration
| Item | | YS6 | YS60 | YS250 | YS600 |
| Range | MPa | 0.04-0.6 | 0.1-6 | 0.5-25 | 1-60 |
| Up limit of
measurement | MPa | 0.6 | 6 | 25 | 60 |
| Down limit of measurement | MPa | 0.04 | 0.1 | 0.5 | 1 |
| Piston nominal area | cm² | 1 | 0.5 | 0.1 | 0.05 |
| Chassis and piston | Nominal mass kg | 0.4 | 0.5 | 0.5 | 0.5 |
| Generatedpressure MPa | 0.04 | 0.1 | 0.5 | 1 |
| Special weight | Nominal mass kg | 0.1;0.5 | 0.5;2.5 | 0.5;2.5 | 0.5;2.5 |
| Generatedpressure MPa | 0.01;0.05 | 0.1;0.5 | 0.5;2.5 | 1;5 |
| Number | 6;10 | 4;11 | 4;9 | 4;11 |
| Both ends of the lock nut | | M20×1.5 | M20×1.5 | M20×1.5 | M20×1.5 |
| Weight | kg | 35 | 60 | 55 | 90 |
| Working liquid | 25#Transformer oil and aviation kerosene mixed (4.39:1).20 ℃
Kinematic viscosity 9 ~ 12 centistokes,
The acid value of less than 0.05 mg KOH/ G | sebacate 20 ℃ kinematic viscosity 20-25 centistokes, acid value is
not greater than 0.05 mg KOH/ G |
|
Advantages dead weight tester pressure gauge calibration
Feature china dead weight tester pressure gauge calibration
1. The piston and cylinder are made of high strength, high
stiffness, and low temperature coefficient of linear expansion of
the carbide grinding tungsten carbide material , with a wide range
of ambient temperature , stable performance 20 ± 5 ℃.
2. The load center of gravity low, weight by Cradle applied
directly to the piston, the piston smooth operation, the pressure
fluctuation is extremely small, accurate indication.
3. When pressure more than 25MPa ,the medium uses a small viscosity
isooctyl sebacate, thus ensuring a very high sensitivity.
4. The weights used are all non-magnetic stainless steel material.
5.The piston displacement sensor used to monitor the working
position, the piston up and down stroke of ±1.5mm, instrument
display is sensitive, smart, and accurate.
6. Wide range, at the lower 1MPa, the basic error of ± 0.02% or ±
0.05%, a KY100 type manometer, capable of reaching the upper limit
of the current domestic 6,60,100MPa three measuring manometer.
7. pressure regulator easy , even at 250MPa pressure could ease.
