Digital Portable Gauge Calibration Pressure Calibrator Complete
With Pump
Description Portable Gauge Calibration Pressure Calibrator Complete With Pump
XY-2006A portable gas pressure source is used in a desktop or a
piston gauge pressure source, pressure calibration sets and other
electric products, these products are generally bulky and not bring
parity to the scene, and foreign products using hand-portable clamp
. Pressurized strenuous, complex operation, combined with the above
reasons, the company recently developed an easy to carry, simple
and effortless operation of the XY-2006A portable gas pressure
source.
Parameter Calibration Portable Gauge Calibration Pressure Calibrator Complete With Pump
1.Range:-95KPa～6MPa
2.Medium:gas
3.Fine Adjust:10KPa
4.Connector:M20×1.5(2 port)
5.Size:270mm×150mm×150mm
Application Portable Gauge Calibration Pressure Calibrator Complete With Pump
Simple structure, effortless operation
Easy to carry, easy to leak, easy maintenance
Moistureproof
Can produce negative (-0.1 ~ 6MPA)
Can be connected to multiple ranges using intelligent digital
pressure calibrator
Operation Portable Gauge Calibration Pressure Calibrator Complete
With Pump
1. Connect the measured instrument and standard instruments to the
outlet (1-2) of the calibrator and tighten it without any wrench or
tools.
2. Positive pressure step-up process verification:
Turn off the exhaust valve counterclockwise(7)Turn on the Pressure
maintaining valve clockwise (3) Confirm the switch valve.(6)At the
positive position,rotate Pressurize handwheel counter-clockwise to
the outermost end. Press the preload handle gently (4)pressurized
to 1MPa and turn off the Pressure maintaining valve (3)rotate
clockwise Pressurize handwheel (5), according to the normal
verification procedures for step-up process verification.
3. step-down process verification:
Counterclockwise rotate Pressurize handwheel(5) or counterclockwise
gently open the exhaust valve (7), according to the normal
verification procedures, the process of testing until the 0 step
down test;
Rotate the output nut (1-2) counter-clockwise gently and remove the
pressure gauge.
4. Negative pressure meter test:
Turn off the exhaust valve clockwise (7), open the Pressure
maintaining valve counterclockwise (3) to confirm the switch valve
(6) in the negative pressure position, rotate Pressurize handwheel
clockwise to the innermost. Tighten the Preload handle (4)
according to the verification procedures to verify the point to the
negative pressure can not rise, close tPressure maintaining valve
(3)counterclockwise rotation the Pressurize handwhee.(5)the
negative pressure will rise.
Return calibration, counterclockwise gently open the exhaust valve,
the backhaul test.
5. After finish test, clean the output dirt, with a random plug
with a good plug to block the output port to prevent dirt into.
